澳洲幸运10开奖结果大小

LOGO
Screenshot_8

Installation Instructions for Polyaspartics

Tools/Equipment Needed

Image

BRUSHES

for cutting in edges
Image

5 mil or 10 mil 18”
ROLLER

sleeves plus cage
with pole attachment
Image

DRILLwith
mixing paddle

Image

Mixing
PAILS

Image

SMALL PAIL

for use with brush to do edges
Image

SHOP

VAC
Image

BROOM

Image

GLOVES

for mixing and coating
Image

Spiked
SHOES

Image

Garbage
BAGS

Image

SMALL TARP

for mixing station
Image

PAINT

Sticks

Installation Steps

01

Prepare surface for proper bonding by diamond grinding, shot blasting or acid etching Vacuum floor to ensure all dust or excess chips are removed (this is critical for adhesion of the coating to the concrete).

02

Prepare all tools necessary for coating (drill, pails, brush, rollers, tray, gloves, etc).

03

Mix equal amounts of parts A and B in a clean mixing pail and drill mix for about 30 seconds. Mix only as much as you will use in 20 minutes.

04

Only mix enough product to do the cutting in. Immediately begin brushing edges around the perimeter and around poles or equipment with a brush. Then mix up enough product that you will be comfortable with to do the main floor. Pour all mixed product on the floor in ribbons and use squeegee to spread the product leaving only enough to cover the floor or decorative chips.

05

Push or pull the flat squeegee at an even speed with a downward pressure. The first coat should be approximately 10-12 mils (133-160 square feet per gallon). Back rolling with an 18” roller is necessary even if coat is applied thin and even as it will ensure that you are not leaving puddles or high spots anywhere. Never mix more product than you can apply in a 15-20 minute period. If you need to apply a second coat you must wait at least 3 hours or until the floor is tack free up until 12 hours. If you pass 24 hours you need to aggressively abrade the surface before applying second coat.

06

Remember you must maintain a wet edge at all times – do not let an area start to dry otherwise you will end up with lines where the wet and the dry product meets.
***Remember to always check to see what the mix ratio is before mixing.

澳洲幸运10开奖最快